Swingarm sliders protect the swingarm, rear axle, and axle nut in a crash and slide. The most common type of swingarm slider is a combination spool/slider, but these are prone to failure. Either the relatively small bolts holding the spools on shear off or the tabs themselves tear off the swingarm when the spools hit the ground. RhinoMoto swingarm sliders fit inside the axle and are supported by the axle when impacted from straight on or from the side. The parts are CNC machined from solid polymer rod for superior strength, fit and finish. Features are machined into each part to allow them to fit over the axle and flush against the swingarm, avoiding that "skateboard wheel stuck on the end of the axle" look. This kit installs in less than one minute per side with only a 5mm key key and pliers. The left side uses a cotter pin to secure the axle nut as it comes from the factory. They remove just as quickly for maintenance and can be reinstalled virtually an unlimited number of times.
This kits fits GSXR and Hayabusa 2002-2007.
Kit 150-0010 includes 2 sliders with locking tapers and stainless steel fasteners, installation instructions and 2 RhinoMoto logo stickers.
